13 Beltpack Registration

The beltpack screen is red and reads NOT REGISTERED.

Sometimes you will need to register a beltpack to our network. This could be either after a factory reset, or because the beltpack is new to us—we rented an additional beltpack to expand the system or to replace one sent to repair.

If it is a new beltpack to us

• Confirm the firmware is the same as our system.
  1. Press MENU
  2. Select SERVICE>INFORMATION>BELTPACK
  3. Note the firmware version [Vxx.xx.xx]
  4. Compare to the firmware version shown at the bottom of the Antenna display.
• Update the beltpack firmware if necessary.
  1. See beltpack firmware instructions.

Registration

We use Antenna-NFC registration mode, which should always be active.

1. Power up the beltpack.
2. Hold the NFC icon on the front of the beltpack against the matching icon on the front of the antenna.
3. The beltpack should vibrate instantly indicating registration.
4. If the beltpack does not register, try the other antenna.
5. If it still doesn’t register, click here.

Profile

• Select profile
• Rename beltpack
• Discuss multiple beltpack with same name problem
• Key assignments on beltpack to beltpack connections